Charcoal machine is a kind of common machine-made charcoal equipment. In the production process of charcoal machine, the quality of machine-made charcoal is related to the economic benefits of the manufacturers. In the actual operation process, due to equipment problems or the operation methods of the staff, the production of sticks Irregularities will still occur, so what is the reason for the irregularities of the charcoal machine?
The core reason that the rod making machine cannot be shaped is that the front thruster of the rod making machine is worn or the angle is wrong, which will cause the rod making machine to not form well. The irregular appearance caused by the equipment wear problem only needs to be repaired. That's it. After repairing, we have to take good care of the wearing parts. In addition to the wear problem, we should also consider the rod forming temperature and raw material moisture, because these factors will also cause the rod to not be formed. Although the machine-made charcoal rod making machine will have some faults during the production process, such as broken charcoal or fragile molding, etc., compared with the problem of not being able to produce rods and not forming, the failure to form is the most serious. If the new rod making machine cannot perform the function of forming rods normally during the production process, then this is not a good rod making equipment.
The charcoal machine does not produce a good result because the raw material of the charcoal machine has too much humidity, and the raw material is not heated according to the requirements of the use. The heating temperature of the charcoal machine is low and the heating temperature is inserted in the spiral groove of the charcoal machine. The charcoal machine is equipped with a groove inside the heating cylinder. Displacement with the heating cylinder grooves and re-install, check the power supply voltage of the charcoal machine is low, the inner sleeve of the bracket is well worn, and the screw propeller is worn and repaired; the reason why the charcoal machine does not form is because the humidity of the charcoal machine is too high, and it must be heated first After the moisture is removed, it is dried by a dryer to reach a certain moisture requirement. The angle of the propeller of the charcoal machine to be heated should be less than 20 degrees, and the number of thermocouples of the propeller should be repaired. Check and install according to the installation position. The heating ring should be checked regularly to ensure the slack. The above is a summary of the mechanism of the physical existence of the charcoal machine equipment not producing rods and not forming rods.