The machine-made charcoal equipment greatly improves the coordination, compactness and wear resistance between the propeller shaft and the inner barrel. It has the advantages of high output, low energy consumption, compactness and durability. The diameter range of the finished rod is between 40-80cm.
When the machine-made charcoal equipment is working normally, the formed rods are evenly extruded from the sleeve. The machine-made rods should be dark brown, uniform in hardness, smooth in surface, without cracks, and the surface of the center hole is also smooth, and the exhaust is smooth. The center of the machine-made rod has a low density or contains scattered sawdust. This is because the diameter of the root of the screw propeller shaft tip needs to be repaired and thickened. Misalignment of the shaft tip can also cause the above problems, and it needs to be corrected at high temperature. If the rod is bent, it may be due to excessive moisture in the raw material.
There are many gaps in the machine-made charcoal equipment to increase the burning time of machine-made charcoal. One of the main methods is to increase the molding pressure of the original parts used by the machine-made charcoal equipment’s rod making machine, and then increase the density and strength of the rod. The second is the machine-made charcoal plant’s machine-made charcoal equipment. The carbonization furnace, by increasing the carbonization temperature of the carbonization furnace, and slowing down the rate of heating and cooling, the produced carbon has high density and high hardness.